Sun Microsystems Enterprise 250 Owner's Manual page 152

3. Pull off the RMA plastic cover from the front of the removable media assembly.
Grasp both sides of the cover and pull it away from the front of the system.
4. Remove the Phillips screw that secures the LED/keyswitch assembly to the front
of the chassis.
5. Pull the top part of the assembly away from the chassis and lift the bottom tab
free from the slot in the chassis wall.
6. Carefully pull the assembly and its attached cables out through the openings in
the chassis wall.
Open the disk access door, if necessary, to gain better access to the LED ribbon cable.
What Next
To replace the LED/keyswitch assembly, complete this task:
"How to Install the LED/Keyswitch Assembly" on page 135
134 Sun Enterprise 250 Server Owner's Guide • June 1998