How To Install The Power Distribution Board - Sun Microsystems Enterprise 250 Owner's Manual

How to Install the Power
Distribution Board
What to Do
1. Position the power distribution board in its mounting brackets on the chassis
ceiling and floor.
Align the two captive screws at the top and bottom edges of the board with the two
holes in the mounting brackets. The four large power connectors along the edge of
the board should face the power supply bays.
2. Tighten the two captive Phillips screws that secure the board to its mounting
brackets.
It helps to separate the board slightly from its mounting brackets in order to engage
the screws in the screw holes.
J0401
J0501
J0201
J0202
J0204
J0205
J0206
J0207
Chapter 8 Removing and Installing Backplanes and Cables 163