Sun Microsystems Enterprise 250 Owner's Manual page 111

2. Insert the SSP card into the SSP rear panel opening.
The SSP paddle card mounts in the top slot opening in the system's rear panel.
3. Secure the SSP card faceplate to the rear panel with the Phillips screw you
removed earlier.
Use a magnetized screwdriver, if possible, to prevent the screw from falling into the
system chassis.
4. Reconnect any external cables to the SSP card's external connectors.
What Next
Complete the following task to reassemble the system:
"How to Install the Side Access Panel" on page 33
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. For additional information, see Chapter 11 "Diagnostics and
Troubleshooting" beginning on page 215.
Chapter 5 Removing and Installing Main Logic Board Components 93