How To Install The Nvram/Tod Module - Sun Microsystems Enterprise 250 Owner's Manual

How to Install the NVRAM/TOD
Module
Caution – This procedure must be performed by a qualified service-trained
maintenance provider. Persons who remove any of the outer panels to access this
equipment must observe all safety precautions and comply with skill level
requirements, certification, and all applicable local and national laws.
Caution – Use only NVRAM/TOD modules that have been specifically
programmed for a Sun Enterprise 250 server.
What to Do
1. Insert the NVRAM/TOD module into its socket on the main logic board.
The carrier is keyed so that an NVRAM/TOD module can be installed only one way.
2. Push down on the NVRAM/TOD module until it seats firmly in the socket.
96 Sun Enterprise 250 Server Owner's Guide • June 1998