Sun Microsystems Enterprise 250 Owner's Manual page 107

3. Secure the PCI card faceplate to the rear panel with the Phillips screw.
4. If necessary, connect any internal cables to the PCI card's internal connectors.
Read the documentation supplied with the PCI card for information about jumper
settings, PCI slot requirements, and cable connections.
5. If necessary, connect any external cables to the PCI card.
Read the documentation supplied with the PCI card for information about external
cable connections.
What Next
Complete the following tasks to reassemble the system:
"How to Install the Side Access Panel" on page 33
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. You must also perform a reconfiguration boot so that your
system is able to recognize the new device(s). For additional information, see:
"How to Initiate a Reconfiguration Boot" on page 29
Chapter 5 Removing and Installing Main Logic Board Components 89