Sun Microsystems Enterprise 250 Owner's Manual page 162

10. Reconnect the LED ribbon cable to connector J0602 at the front of the UltraSCSI
backplane.
This connector is located in the upper-left corner of the backplane (as viewed from
the front). Make sure that the label at the end of the cable faces up. Press down the
connector collar to secure the connection.
11. Reconnect the remaining cables to the rear of the UltraSCSI backplane:
a. Connect the UltraSCSI data cable to connector J0102.
b. Connect the UltraSCSI power cable to connector J0101.
c. Connect the keyswitch cable (from the LED/keyswitch assembly)
to connector J0601.
d. Connect the keyswitch/LED cable to connector J0103.
144 Sun Enterprise 250 Server Owner's Guide • June 1998