Connect The Cords And Cables - Sun Microsystems Fire V490 Setup And Rackmounting Manual

Connect the Cords and Cables

The following figure shows the Sun Fire V490 server back panel and identifies the
AC power inlet and the I/O ports.
TABLE 3-1
Back Panel Port
1 One of two AC inlets for power
cords
2 Ethernet ports
3 Serial port
4 HSSDC FC-AL port
5 USB ports
40 Sun Fire V490 Server Setup and Rackmounting Guide • August 2004
Back Panel Ports
Information
Connect a power cord to each AC inlet. See
Cords" on page
only.
Connect a TPE cable to at least one Ethernet port. See
a Twisted-Pair Ethernet Cable" on page
Use this port to set up a tip connection or to connect an ASCII
terminal. See the Sun Fire V490 Server Administration Guide for
instructions. If you are connecting to an ASCII terminal, use an
RJ-45 cable and the DB-25 adapter (Sun Part Number 530-2889-
03) included in the ship kit.
See the Sun Fire V490 Server Administration Guide for information
about this port.
See the Sun Fire V490 Server Administration Guide for information
about the devices you can connect to these ports.
5
1
0
1
2
0 )
0 0
/ 1
0 0
/ 1
(1 0
0
3
A L
R I
S E
4
2
8 -0
2 5
3 -1
2 6
L :
L B
1
41. The V490 server uses 200-240 VAC line input
"Connect the Power
"Connect
44.