How To Remove The Ssp Paddle Card - Sun Microsystems Enterprise 250 Owner's Manual

How to Remove the SSP Paddle Card

The System Service Processor (SSP) paddle card is mounted in the top slot opening
in the system's rear panel.
Before you Begin
Complete these tasks:
"How to Power Off the System" on page 26
"How to Remove the Side Access Panel" on page 31
"How to Avoid Electrostatic Discharge" on page 35
What to Do
1. Disconnect any cables from the external faceplate of the SSP card.
2. Remove the Phillips screw that secures the card faceplate to the system rear panel.
Use a magnetized screwdriver, if possible, to prevent the screw from falling into the
system chassis. Save the screw for when you install the replacement SSP card.
90 Sun Enterprise 250 Server Owner's Guide • June 1998