Sun Microsystems Enterprise 250 Owner's Manual page 129

6. Align the disk drive to its drive bay.
Orient the drive so the drive handle's hinge faces the bottom of the drive bay (the
left side of the bay in a rackmount configuration).
Note – If you are replacing a drive that you removed previously, be sure to install
the drive in the same drive bay as the one you removed.
7. Holding the drive by its handle, fit the drive into the guide rails at the top and
bottom of the drive bay.
8. Slide the drive into the bay until it barely contacts the backplane.
9. Press carefully on the center of the drive and watch as the handle begins to close.
The drive handle begins to close as the drive engages its backplane connector.
10. Press the handle toward the drive until the latch closes, securing the drive
in place.
11. Close the disk access door and lock it if necessary.
Chapter 6 Removing and Installing Storage Devices 111