Sun Microsystems Enterprise 250 Owner's Manual page 158

3. Remove the plastic outer panel that partially covers the top of the chassis:
Only the top portion of the panel must be removed.
a. Using a flat-blade screwdriver as a lever, carefully flex the panel as shown
below to disengage it from the chassis.
b. Slide the panel toward the rear of the system until the hooks beneath the panel
are disengaged from the chassis.
c. Pull the bottom center edge of the panel outward until it disengages from
the chassis.
Lift the panel off the system and set it aside.
4. Carefully lower the chassis onto its closed side.
Enlist the help of another person to accomplish this safely.
Do not lift the chassis using the plastic panels at the front or the side of the chassis.
Roll the system onto a solid surface that spaces the unit about 2 inches (5 cm) off the
floor; for example, use a pair of wooden boards. Do not allow any of the weight to
rest on the plastic panels at the front of the chassis.
140 Sun Enterprise 250 Server Owner's Guide • June 1998