Sun Microsystems Enterprise 250 Owner's Manual page 154

7. Reattach the RMA plastic cover to the front of the removable media assembly.
Align the clips on either side of the cover with the small rectangular slots in the
chassis wall. Push evenly on both sides of the cover to secure it to the chassis.
8. Grasp the corner of the LED ribbon cable, and fold the cable under itself, so that
the label at the end is facing up.
Make sure that the adhesive strip at the corner of the cable is also facing up.
9. Feed the end back into the disk bay opening and route it on top of the disk cage
toward the upper-left corner of the UltraSCSI backplane.
Arrange the middle portion of the cable so that it lies flat across the top of the disk
cage at the front of the chassis.
10. Connect the LED ribbon cable to connector J0602 on the UltraSCSI backplane.
This connector is located at the upper-left corner of the backplane (as viewed from
the front). Make sure that the label at the end of the cable faces up. Press down the
connector collar to secure the connection.
11. Secure the LED ribbon cable to the underside of the removable media shelf.
At the front-left corner of the system, the LED ribbon cable should be secured to the
underside of the removable media shelf. The corner of the cable has a strip of
double-sided adhesive tape. Peel off the paper backing from the adhesive strip, and
secure the cable to the underside of the removable media shelf.
136 Sun Enterprise 250 Server Owner's Guide • June 1998