Sun Microsystems Enterprise 250 Owner's Manual page 32

Insert the female end of the power cord through the plastic tie-wrap loop located to
the right of the supply. Tighten the tie-wrap to secure the connection.
Note – If your server includes a second power supply, connect its AC power cord in
the same manner. You may connect the second power supply to the same circuit as
the first supply. However, for increased system redundancy, you should connect the
two power supplies to separate circuits.
4. Install any optional components shipped with your system.
Many of the options ordered with your system may have been pre-installed at the
factory. However, if you ordered options that were not factory-installed, see the
following sections for installation instructions:
How to Install a Memory Module — page 79
How to Install a CPU Module — page 83
How to Install a PCI Card — page 87
How to Install a Disk Drive — page 110
How to Install a CD-ROM Drive or Tape Drive — page 115
How to Install the Diskette Drive — page 120
How to Install a Power Supply — page 130
How to Install the Floor Casters Assembly — page 148
How to Install the Chassis Foot Glides — page 152
14 Sun Enterprise 250 Server Owner's Guide • June 1998