How To Install The Led/Keyswitch Assembly - Sun Microsystems Enterprise 250 Owner's Manual

How to Install the LED/Keyswitch
Assembly
What to Do
1. Unlock the disk access door and swing it open.
2. Grasp the cables attached to the LED/keyswitch assembly and feed them through
the appropriate openings in the front of the chassis.
Feed the keyswitch cable through the small round opening and the LED ribbon cable
through the rectangular opening below it.
3. Route the keyswitch cable straight back toward the UltraSCSI backplane.
4. Thread the LED ribbon cable straight down behind the chassis wall and pull it
out through the disk bay opening.
5. Insert the bottom portion of the LED/keyswitch assembly into the rectangular
opening at the front of the chassis.
Position the assembly so that the bottom tab rests inside the chassis.
6. Replace the Phillips screw that secures the top portion of the assembly to the
chassis wall.
Chapter 7 Removing and Installing Miscellaneous Assemblies 135