How To Install A Cd-Rom Drive Or Tape Drive - Sun Microsystems Enterprise 250 Owner's Manual

How to Install a CD-ROM Drive or
Tape Drive
Before You Begin
Know the configuration guidelines for installing removable media devices, see:
"About the SCSI Removable Media Bays and the External SCSI Port" on page 67
Complete these tasks:
"How to Power Off the System" on page 26
"How to Remove the Side Access Panel" on page 31
"How to Avoid Electrostatic Discharge" on page 35
"How to Remove the Removable Media Assembly (RMA)" on page 100
What to Do
1. If necessary, remove the metal filler panel from the appropriate drive bay in the
removable media assembly.
To release the panel, deflect its two retainer tabs through the small rectangular slots
on each side of the RMA enclosure.
2. If necessary, remove the plastic filler panel from the RMA plastic cover.
On the back side of the RMA cover, push the filler panel retainer tabs inward to
disengage the filler panel.
3. If you are replacing a defective drive, make sure that the jumper settings on the
new drive match the settings on the old drive.
4. Slide the CD-ROM or tape drive into its drive bay.
Align the two screw holes on each side of the drive with the corresponding holes in
each side of the drive bay.
Chapter 6 Removing and Installing Storage Devices 115