Sun Microsystems Enterprise 250 Owner's Manual page 109

3. Remove the SSP card from its rear panel opening.
4. Disconnect the SSP data cable from the main logic board at connector J4201.
a. Lift up the collar on the SSP cable connector.
b. Remove the SSP data cable from the connector.
5. Place the SSP card and data cable on an antistatic mat.
6. If you are not replacing the SSP card, install a PCI filler panel into the vacated
SSP slot.
Secure the filler panel with the screw from the PCI faceplate.
What Next
To replace an SSP card, complete this task:
"How to Install the SSP Paddle Card" on page 92
Chapter 5 Removing and Installing Main Logic Board Components 91