No Monitor; Show Monitor Session; Show Port - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Format
Mode

4.1.14 no monitor

This command removes all the source ports and a destination port and restores the default
value for mirroring session mode for all the configured sessions.
Note: This is a stand-alone "no" command. This command does not have a
Default
Format
Mode

4.1.15 show monitor session

This command displays the port monitoring information for the system. The
parameter is an integer.
Format
Mode
Session ID
Admin Mode
Probe Port
Mirrored Port The interface configured as the mirrored port.

4.1.16 show port

This command displays port information.
Format
Mode
Interface
Type
Port and System Setup Commands
no monitor session <session-id>
Global Config
"normal" form.
enabled
no monitor
Global config
show monitor session <sessionid>
Privileged EXEC
The session identifying number.
Indicates whether the Port Monitoring feature is enabled or
disabled. The possible values are enable and disable.
The interface configured as the probe port.
show port {<slot/port> | all}
Privileged EXEC
Valid slot and port number separated by forward slashes.
If not blank, this field indicates that this port is a special type
of port. The possible values are:
v1.0, February 2007
<sessionid>
4-7