Otto Bock Pheon 3R62 Instructions For Use Manual page 37

Hide thumbs Also See for Pheon 3R62:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 24
5.7.4 Adjusting the Swing Phase Friction
Function
Swing phase friction
Tools required:
>
Allen key (4 mm)
► CAUTION! The prosthetic knee joint has to reach full extension, even at slower walk­
ing speeds. Observe the information in the section "Fine-tuning the Settings" (see
Page 37).
Using the screwdriver, adjust extension damping so that the prosthetic knee joint does not
swing too hard against the extension stop and so that the prosthetic foot swings through suffi­
ciently according to the needs of the patient.
5.7.5 Fine-tuning the Settings
► CAUTION! The various settings of the prosthetic knee joint cannot be adjusted entirely
independently of each other. When the settings cannot be fully adjusted to the com­
fort needs of the patient, the settings should be established primarily based on safety
aspects.
Adapt the settings of the prosthetic knee joint to the patient by means of fine-tuning and exer­
cises.
If the extension position is not reached with every step and at any walking speed, reduce the
braking effect and/or increase the initial tension of the extension assist.
► Check the adjustment of the prosthesis settings during normal consultations and the annual
safety inspection.
Advise the patient to check the prosthesis if changes in function occur.
5.8 Finishing the Prosthesis
Required tools:
>
Torque wrench
1) Tighten all screws of the prosthetic components to the specified installation torque values.
2) Verify proper functioning of the prosthesis.
6 Use
6.1 Information for Use
NOTICE
Mechanical overload
Impaired functionality due to mechanical damage
Check the product for damage prior to each use.
Do not use the product if its functionality has been impaired.
Take any necessary measures (e.g. repair, replacement, inspection by the manufacturer's
customer service, etc.).
Inform the patient.
Means of adjustment
Adjusting screw
(see fig. 14 -
)
Setting
Rotate anticlockwise
Rotate clockwise
Meaning
Decrease braking effect
Speed up extension
Extension
stop
gets
louder
Increase braking effect
Slow down extension
Extension
stop
gets
quieter
Ottobock | 37

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents