Set Subsystem - IBM System Storage DS3000 Programming Manual

DS3524-DTL Daily / Weekly - Mon - Fri 05/23/2012 02:00AM 05/30/2012
DS3400A None
DS5100-DTL None
SMcli completed successfully.
Note: In Microsoft Windows OS, the command prompt window must have administrator authority or the
command will fail with an error message as shown below:
C:\Program Files (x86)\IBM_DS\client>SMcli -supportBundle auto disable all
Incorrect Usage
... ... ...
Do not modify any parameters to the command. Some examples are as follows:
Incorrectly modified parameters
SMcli 10.12.128.1 10.12.128.2 -supportBundle
schedule show
SMcli 10.12.128.1 10.12.128.2 -c "-supportBundle
schedule show"
SMcli -supportbundle schedule show

Set subsystem

This command defines the properties for an subsystem.
Syntax
set subsystem [subsystemNumber]
addDrives=(enclosureID1,drawerID1,slotID1 ... enclosureIDn,drawerIDn,slotIDn)
raidLevel=(0 | 1 | 3 | 5 | 6)
owner=(a | b)
Parameters
Parameter
subsystem
addDrives
raidLevel
owner
3-184
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
Description
The alphanumeric identifier (including - and _) of the
subsystem for which you want to set properties. Enclose the
subsystem identifier in square brackets ([ ]).
The location of the disk drive that you want to add to the
subsystem. For high-capacity disk drive expansion
enclosures, specify the enclosure ID value, the drawer ID
value, and the slot ID value for the disk drive. For
low-capacity drive expansion enclosures, specify the
enclosure ID value and the slot ID value for the disk drive.
Enclosure ID values are 0 to 99. Drawer ID values are 1 to 5.
Slot ID values are 1 to 32. Enclose the enclosure ID value, the
drawer ID value, and the slot ID value in parentheses.
The RAID level for the subsystem. Valid values are 0, 1, 3, 5,
or 6.
The controller that owns the subsystem. Valid controller
identifiers are a or b, where a is the controller in slot A, and
b is the controller in slot B. Use this parameter only if you
want to change the subsystem owner.
Advisory
Do not specify IP addresses
Do not specify IP addresses and -c parameter
Note that supportBundle parameter is case sensitive and
must be typed accordingly.