Download Enclosure Configuration Settings - IBM System Storage DS3000 Programming Manual

v Ensure that the firmware image file is compatible with the drive enclosure. If you download a
firmware image file that is not compatible with the drive enclosure that you have selected, the drive
enclosure might become unusable.
v Do not make any configuration changes to the storage subsystem while you download drive firmware.
Trying to make a configuration change can cause the firmware download to fail and make the selected
drives unusable.
When you download the firmware to the drives, you must provide the full path and file name to the
firmware image that is stored on your system.
You can use download drive command to test the firmware on one drive before you install the firmware
on all of the drives in a storage subsystem. The download returns one of these statuses:
v Successful
v Unsuccessful With Reason
v Never Attempted With Reason
The drive parameter supports both high-capacity drive enclosures and low-capacity drive enclosures. A
high-capacity drive enclosure has drawers that hold the drives. The drawers slide out of the drive
enclosure to provide access to the drives. A low-capacity drive enclosure does not have drawers. For a
high-capacity drive enclosure, you must specify the identifier (ID) of the drive enclosure, the ID of the
drawer, and the ID of the slot in which a drive resides. For a low-capacity drive enclosure, you need only
specify the ID of the drive enclosure and the ID of the slot in which a drive resides. For a low-capacity
drive enclosure, an alternative method for identifying a location for a drive is to specify the ID of the
drive enclosure, set the ID of the drawer to 0, and specify the ID of the slot in which a drive resides.

Download Enclosure Configuration Settings

This command downloads the factory default settings to all of the drive enclosures in a storage
subsystem or to a specific drive enclosure in a storage subsystem.
Syntax
download (allEnclosures | enclosure [enclosureID]) configurationSettings
firmware file="filename"
Parameters
Parameter
allEnclosure
enclosure
file
Notes
The enclosure parameter downloads the factory default configuration settings to a specific drive
expansion enclosure. If you need to download the factory default configuration settings to more than one
drive expansion enclosure, but not all drive expansion enclosures, you must enter this command for each
drive expansion enclosure.
3-126
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
Description
This parameter downloads new firmware to all of the
enclosures in the storage subsystem.
The drive enclosure that contains the ESM card to which
you want to load new firmware. Enclosure ID values are 0
to 99. Enclose the enclosure ID value in square brackets ([ ]).
The file path and the file name of the file that contains the
firmware image. Enclose the file path and the file name of
the firmware image in double quotation marks (" "). For
example: file="C:\Program Files\CLI\dnld\
enclosureset.dlp". Valid file names have a .dlp extension.