IBM System Storage DS3000 Programming Manual page 125

[repositorysubsystemUserLabel="repositorysubsystemName"
enclosureLossProtect=(TRUE | FALSE)
drawerLossProtect=(TRUE | FALSE)
freeCapacityArea=freeCapacityIndexNumber
userLabel="flashcopyLogicalDriveName"
warningThresholdPercent=percentValue
repositoryPercentOfBase=percentValue
repositoryUserLabel="repositoryName"
repositoryFullPolicy=(failBaseWrites | failFlashcopy)
enableSchedule=(TRUE | FALSE)
schedule=(immediate | flashcopySchedule)]
Syntax (Existing Repository subsystem)
create flashcopyLogicalDrive baseLogicalDrive="baseLogicalDriveName"
[repositorysubsystem="repositorysubsystemName" repositoryUserLabel="repositoryName"
freeCapacityArea=freeCapacityIndexNumber
userLabel="flashcopyLogicalDriveName"
warningThresholdPercent=percentValue
repositoryPercentOfBase=percentValue
repositoryFullPolicy=(failBaseWrites | failFlashcopy)
enableSchedule=(TRUE | FALSE)
schedule=(immediate | flashcopySchedule)]
Parameters
Parameter
baseLogicalDrive
repositoryRAIDLevel
repositoryDrives
repositoryDriveCount
repositorysubsystemUserLabel The alphanumeric identifer (including - and _) of the
repositorysubsystem
Description
The name of the base logical drive from which you want
to take a FlashCopy . Enclose the base logical drive name
in double quotation marks (" ").
Use this parameter when you create a new subsystem.
The RAID level for the FlashCopy repository logical
drive. Valid values are 1, 3, 5, or 6.
Use this parameter when you create a new subsystem.
The disk drives that you want to assign to the FlashCopy
repository subsystem.For high-capacity disk drive
expansion enclosures, specify the enclosure ID value, the
drawer ID value, and the slot ID value for the disk drive.
For low-capacity drive expansion enclosures, specify the
enclosure ID value and the slot ID value for the disk
drive. Enclosure ID values are 0 to 99. Drawer ID values
are 1 to 5. Slot ID values are 1 to 32. Enclose the
enclosure ID value, the drawer ID value, and the slot ID
value in parentheses.
Use this parameter when you create a new subsystem.
The number of unassigned disk drives that you want to
use for the FlashCopy repository logical drive.
subsystem where the FlashCopy repository logical drive
is located.
The name of an existing subsystem where you want to
place the repository logical drive. Use this parameter if
you do not want to put the repository logical drive in
the same subsystem as the base logical drive. The default
is to use the same subsystem for both the base logical
drive and the repository logical drive. Enclose the name
of the repository subsystem in double quotation marks
(" ").
Chapter 3. Script Commands
3-79