Set Controller - IBM System Storage DS3000 Programming Manual

Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for
the names. Names can have a maximum of 30 characters.

Set Controller

This command defines the attributes for the controllers.
Syntax
set controller [(a | b)]
availability=(online | offline | serviceMode) |
ethernetPort [(1 | 2)] ethernetPortOptions |
globalNVSRAMByte [nvsramOffset]=(nvsramByteSetting | nvsramBitSetting) |
hostNVSRAMByte [hostType, nvsramOffset]=(nvsramByteSetting | nvsramBitSetting) |
IPv4GatewayIP=ipAddress | IPv6RouterAddress=ipv6Address |
iscsiHostPort [(1 | 2 | 3 | 4)] iscsiHostPortOptions |
rloginEnabled=(TRUE | FALSE) |
serviceAllowedIndicator=(on | off
Parameters
Parameter
controller
availability
ethernetPort
globalNVSRAMByte
hostNVSRAMByte
hostNVSRAMByte
IPv4GatewayIP
Description
The controller for which you want to define
properties. Valid identifiers for the controller are a or
b, where a is the controller in slot A and b is the
controller in slot B. Enclose the controller identifier
in square brackets ([ ]). If you do not specify a
controller, the firmware for the controller returns a
syntax error.
The mode for the controller. The controller modes are
online, offline, or serviceMode.
The attributes (options) for the management Ethernet
ports. The entries to support this parameter are listed
in the "Syntax Element Statement Data" table that
follows. Many settings are possible, including setting
the IP address, the gateway address, and the subnet
mask address.
A portion of the controller NVSRAM. Specify the
region that you want to modify by using the starting
byte offset within the region, and the size and value
of the new data to be stored into NVSRAM.
The NVSRAM for the host-specific region. The
setting specifies the host index for the specific host,
the starting offset within the region, the number of
bytes, and the values to be written.
The NVSRAM for the host-specific region. The
setting specifies the host index for the specific host,
the starting offset within the region, the number of
bytes, and the the byte value or bit value of the new
data to be stored into the NVSRAM.
The IP address of the node that provides the
interface to the network. The address format for the
IPv4 gateway is (0–255).(0–255).(0–255).(0–255)
Chapter 3. Script Commands
3-191