Convert Flashcopy Logical Drive To Enhanced Flashcopy Group; Create Subsystem - IBM System Storage DS3000 Programming Manual

Syntax
Attention: The SM CLI support bundle commands must be run from the SM CLI command line
interface only. They cannot be run from the storage subsystem SM CLI script window. In addition, the
storage subsystem IP addresses are not required. Also, the -c parameter is not required to precede the SM
CLI support bundle command.
<install Path>SMcli -supportBundle auto (enable|disable) (all | storageSubsystemName) [data=pathName]
Parameters
Parameter
enable
disable
all
storageSubsystemName
data

Convert FlashCopy Logical Drive to Enhanced FlashCopy Group

This command migrates from a FlashCopy logical drive to an Enhanced FlashCopy group, and converts
from an existing FlashCopy repository logical drive to an Enhanced FlashCopy image repository logical
drive. A maximum of four FlashCopies can be converted to an Enhanced FlashCopy group. The
FlashCopies must be in a Disabled state and must not be involved in a VolumeCopy operation. The base
logical drive can have only four FlashCopies . If the base logical drive has more than four FlashCopies,
you must delete the extra FlashCopies before running this command.
Note: You must disable any FlashCopies before attempting to convert from a FlashCopy logical drive to
an Enhanced FlashCopy group. Use the disableFlashcopy command to disable a FlashCopy .
Syntax
convert flashcopyLogicalDrive baseLogicalDrive="baseLogicalDriveName"
Parameters
Parameter
baseLogicalDrive

Create subsystem

This command creates either a free-capacity subsystem or one logical drive on a set of unassigned disk
drives.
Description
Enable automatic collection of support bundles when a
critical MEL event is detected.
Disable automatic collection of support bundles where
the feature was previously enabled.
Apply the command to all storage subsystems detected
from the host.
Apply the command to the named storage subsystem
that is in the Storage Manager Enterprise management
window domain. The names of the storage subsystems
can be displayed using the SMcli command with the -d
parameter.
Store the data generated by the command at the location
specified by the pathName.
Description
The alphanumeric identifier (including - and _) of the
base logical drive that has the FlashCopies that you want
to convert into an Enhanced FlashCopy group. Enclose
the base logical drive name in double quotation marks ("
").
Chapter 3. Script Commands
3-55