Show Host Ports; Show Logical Drive - IBM System Storage DS3000 Programming Manual

Parameters
Parameter
controller
progressOnly
file
Note: The progressOnly parameter is useful for seeing the progress of command scripts that need to
sequentially complete operations.

Show Host Ports

For all of the HBA host ports that are connected to a storage subsystem, this command returns this
information:
v The HBA host port identifier
v The HBA host port name
v The HBA host type
Syntax
show allHostPorts
Parameters
None.
Notes
This command returns HBA host port information similar to this example:
HOST PORT IDENTIFIER
12:34:56:54:33:22:22:22 Jupiter1
12:34:56:78:98:98:88:88 Pluto1
54:32:12:34:34:55:65:66 Undefined

Show Logical Drive

For the logical drives in a storage subsystem, this command returns the following information:
v The number of logical drives
v The name
v The status
v The capacity
v The RAID level
v The subsystem where the logical drive is located
3-264
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
Description
The controller that has the host interface card on which you
are running the diagnostic tests. Valid controller identifiers
are a or b, where a is the controller in slot A, and b is the
controller in slot B. Enclose the controller identifier in square
brackets ([ ]). If you do not specify a controller, the storage
management software returns a syntax error.
The progressOnly parameter, shows the progress of the
diagnostic test without waiting for the diagnostic tests to
completely finish.
The name of the file that contains the results of the
diagnostic tests. This command does not automatically
append a file extension to the file name. You must add an
extension when you enter the file name.
HOST PORT NAME HOST TYPE
Solaris
Windows 2000/Server 2003 Clustered
Undefined