IBM System Storage DS3000 Programming Manual page 239

IPv4ConfigurationMethod=(static | dhcp) |
IPv6ConfigurationMethod=(static | auto) |
IPv4GatewayIP=(TRUE | FALSE) |
IPv6HopLimit=[0-255] |
IPv6NdDetectDuplicateAddress=[0-256] |
IPv6NdReachableTime=[0-65535] |
IPv6NdRetransmitTime=[0-65535] |
IPv6NdTimeOut=[0-65535] |
IPv4Priority=[0-7] |
IPv6Priority=[0-7] |
IPv4SubnetMask=(0-255).(0-255).(0-255).(0-255) |
IPv4VlanID=[1-4094] |
IPv6VlanID=[1-4094] |
maxFramePayload=[framesize] |
tcpListeningPort=[3260, 49152-65536] |
portSpeed=[(autoNegotiate | 1 | 10)]
Notes
Before firmware version 7.75, the set controller command supported an NVSRAMByte parameter. The
NVSRAMByte parameter is deprecated and must be replaced with either the hostNVSRAMByte
parameter or the globalNVSRAMByte parameter.
When you use this command, you can specify one or more of the parameters. You do not need to use all
of the parameters.
Setting the availability parameter to serviceMode causes the alternate controller to take ownership of all
of the virtual disks. The specified controller no longer has any logical drives and refuses to take
ownership of any more logical drives. Service mode is persistent across reset cycles and power cycles
until the availability parameter is set to online.
Use the show controller NVSRAM command to show the NVSRAM.
When the duplexMode option is set to TRUE, the selected Ethernet port is set to full duplex. The default
value is half duplex (the duplexMode parameter is set to FALSE).
To make sure that the IPv4 settings or the IPv6 settings are applied, you must set these iscsiHostPort
options:
v enableIPV4= TRUE
v enableIPV6= TRUE
The IPv6 address space is 128 bits. It is represented by eight 16-bit hexadecimal blocks separated by
colons.
The maxFramePayload parameter is shared between IPv4 and IPv6. The payload portion of a standard
Ethernet frame is set at 1500, and a jumbo Ethernet frame is set at 9000. When using jumbo frames, all of
the devices that are in the network path should be capable of handling the larger frame size.
The portSpeed option is expressed as megabits per second (Mb/s).
Values for the portSpeed option of the iscsiHostPort parameter are in megabits per second (Mb/s).
The following values are the default values for the iscsiHostOptions:
3-193
Chapter 3. Script Commands