Show Storage Subsystem Diagnostic Data Capture; Show Storage Subsystem Features; Show Storage Subsystem Unconfigured Iscsi Initiators - IBM System Storage DS3000 Programming Manual

Show Storage Subsystem Diagnostic Data Capture

This command show details of the diagnostic data capture on the controller cache, if a diagnostic data
capture is available.
Syntax
show storageSubsystem ddc
Parameters
None.

Show Storage Subsystem Features

This command lists the feature configuration of a storage subsystem. This command returns information
that shows which features are enabled, disabled, evaluation, and available to be installed.
Syntax
show storagesubsystem features
Parameters
None.
Notes
This command returns the feature information in a format similar to this example.
PREMIUM FEATURE
driveSlotLimit
SSDSupport
highPerformanceTier
remoteMirror
safeStoreExternalKeyMgr
safeStoreSecurity
VolumeCopy

Show storage subsystem unconfigured iSCSI Initiators

This command returns a list of initiators that have been detected by the storage subsystem but are not yet
configured into the storage subsystem topology.
Syntax
show storageArray unconfiguredIscsiInitiators
Parameters
None
Minimum Firmware Level
7.10
3-276
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
STATUS
Enabled (12 of 192 used)
Disabled - Feature Key required
Disabled - Feature Key required
Disabled/Deactivated - Feature Key require
Disabled - Feature Key required
Disabled - Feature Key required
Disabled - Feature Key required