1489 GB 0 %
1675 GB 0 %
1862 GB 0 %
* = Current Performance Read Cache physical capacity.
Minimum Firmware Level
7.84
Stop VolumeCopy
This command stops a VolumeCopy operation. This command is valid for both FlashCopy VolumeCopy
pairs and new Enhanced FlashCopy VolumeCopy pairs.
Syntax
stop volumeCopy target [targetName] source
[sourceName]
Parameters
Parameter
target
source
Minimum Firmware Level
5.40
Stop Array locate
This command turns off the indicator lights on the drives that were turned on by the start volumeGroup
locate command.
Syntax
stop volumeGroup locate
Parameters
None
Minimum Firmware Level
6.16
3-316
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
Description
The name of the target volume for which you want to
stop a VolumeCopy operation. Enclose the target volume
name in square brackets ([ ]). If the target volume name
has special characters, you also must enclose the target
volume name in double quotation marks (" ").
The name of the source volume for which you want to
stop a VolumeCopy operation. Enclose the source
volume name in square brackets ([ ]). If the source
volume name has special characters, you also must
enclose the source volume name in double quotation
marks (" ").
Need help?
Do you have a question about the System Storage DS3000 and is the answer not in the manual?