Export Storage Subsystem Security Key - IBM System Storage DS3000 Programming Manual

You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Names can have a maximum of 30 characters.
When you choose the primary logical drive and the secondary logical drive, the secondary logical drive
must be of equal or greater size than the primary logical drive. The RAID level of the secondary logical
drive need not be the same as the primary logical drive.
Minimum Firmware Level
7.84

Export Storage Subsystem Security Key

This command saves a full disk encryption (FDE) security key to a file. You can transfer the file from one
storage subsystem to another storage subsystem. The file enables you to move FDE drives between
storage subsystems.
Syntax
export storageSubsystem securityKey
passPhrase=passPhraseString |
file=fileName
Parameters
Parameter
The character string that provides authentication for the
passPhrase
security key. The pass phrase is 8 to 32 characters in length.
You must use at least one number, one lowercase letter, one
uppercase letter, and one nonalphanumeric character in the
pass phrase. A space is not permitted.
The name of the file to which you want to save the security
file
key. You must add a file extension of .slk to the end of the
file name.
Notes
For more information about exporting the storage subsystem security key, see the DS Storage Manager
Installation and User's Guide version 10.
The pass phrase must:
v Be between eight and 32 characters long.
v Contain at least one uppercase letter.
v Contain at least one lowercase letter.
v Contain at least one number.
v Contain at least one non-alphanumeric character, for example, < > @ +.
If your pass phrase does not meet these criteria, you receive an error message and are prompted to retry
the command.
3-136
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
Description