Exit Status; Exit Status - IBM System Storage DS3000 Programming Manual
Hide thumbs
Also See for System Storage DS3000:
- Introduction and implementation manual (602 pages) ,
- Installation manual (38 pages) ,
- Owner's manual (18 pages)
Table of Contents
Advertisement
Exit status
The exit statuses that might be returned, and the meaning of each status are listed in the following table:
Table 1-4. Exit Status
Status Value Meaning
0
The command terminated without an error.
1
The command terminated with an error. Information about the
error also appears.
2
The script file does not exist.
3
An error occurred while opening an output file.
4
A storage subsystem was not at the specified address.
5
Addresses specify different storage subsystems.
6
A storage subsystem name does not exist for the host agent that
is connected.
7
The storage subsystem name was not at the specified address.
8
The storage subsystem name was not in the configuration file.
10
A management class does not exist for the storage subsystem.
11
A storage subsystem was not found in the configuration file.
12
An internal error occurred.
13
Invalid script syntax was found.
14
The controller was unable to communicate with the storage
subsystem.
15
A duplicate argument was entered.
16
An execution error occurred.
17
A host was not at the specified address.
18
The WWID was not in the configuration file.
19
The WWID was not at the address.
20
An unknown IP address was specified.
21
The Event Monitor configuration file was corrupted.
22
The storage subsystem was unable to communicate with Event
Monitor.
23
The controller was unable to write alert settings.
24
The wrong organizer node was specified.
25
The command was not available.
26
The device was not in the configuration file.
27
An error occurred while updating the configuration file.
28
An unknown host error occurred.
29
The sender contact information file was not found.
30
The sender contact information file could not be read.
31
The userdata.txt file exists.
32
An invalid -I value in the email alert notification was specified.
33
An invalid -f value in the email alert notification was specified.
1-12
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
Advertisement
Table of Contents
