Show Storage Subsystem Unconfigured Iscsi Initiators; Show Volumecopy - IBM System Storage DS3000 Programming Manual

Thin logicalDrive name: logicalDrive-nameRepository logicalDrive Name: REPOS_NNNN
Logged Time
MM/DD/YYYY HH:MM:SS
With the consumedCapacity parameter, the command returns information similar to the example shown
below:
Logical Drive Provisioned Capacity Consumed Capacity
logicaldriveName 500.000 GB

Show Storage Subsystem Unconfigured iSCSI Initiators

This command returns a list of initiators that have been detected by the storage subsystem but are not yet
configured into the storage subsystem topology.
Syntax
show storageSubsystem unconfiguredIscsiInitiators
Parameters
None.

Show VolumeCopy

This command returns this information about VolumeCopy operations:
v The copy status
v The start time stamp
v The completion time stamp
v The copy priority
v The source logical drive World-Wide Identifier (WWID) or the target logical drive WWID
v The target logical drive Read-Only attribute setting
You can retrieve information about a specific VolumeCopy pair or all of the VolumeCopy pairs in the
storage subsystem.
Syntax
show VolumeCopy (allLogicalDrives | source ["sourceName"] |
target ["targetName"])
Parameters
Parameter
allLogicalDrives
source
Expansion Type
Manual|Automatic
230.000 GB
Description
The setting to return information about VolumeCopy
operations for all of the VolumeCopy pairs.
The name of the source logical drive about which you
want to retrieve information. Enclose the source logical
drive name in double quotation marks (" ") inside of
square brackets ([ ]).
Start Capacity
NNNNNNNN bytes
Quota
700.000 GB
Chapter 3. Script Commands
End Capacity
NNNNNNNN bytes
% Prov. Consumed
46%
3-281