Stop Host Interface Card Diagnostic; Stop Storage Subsystem Iscsi Session; Stop Performance Read Cache Performance Modeling - IBM System Storage DS3000 Programming Manual

Syntax
stop rollback logicaldrive [flashcopyLogicalDriveName]
Parameters
Parameter
logicaldrive

Stop Host Interface Card Diagnostic

This command stops the host interface card diagnostic tests that were started by the start host
carddiagnostic command.
Syntax
stop host card controller [(a | b)] diagnostic
Parameters
Parameter
controller

Stop Storage Subsystem iSCSI Session

This command forces the termination of a storage subsystem iSCSI session.
Syntax
stop storageSubsystem iscsiSession [integer]
Parameter
Parameter
iscsiSession

Stop Performance Read Cache performance modeling

This command stops the performance modeling operation and displays the performance modeling data
for the Performance Read Cache. Before running this command, you must start the performance
modeling operation with the start performanceReadCache performanceModeling command. Optionally,
you can save the data to a file.
3-314
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
Description
The controller that has the host interface card on which you
are running the diagnostic tests. Valid controller identifiers
are a or b, where a is the controller in slot A, and b is the
controller in slot B. Enclose the controller identifier in square
brackets ([ ]). If you do not specify a controller, the storage
management software returns a syntax error.
Description
The identifier number of the iSCSI session. Enclose the
identifier number of the iSCSI session in square brackets ([ ]).
Description
The name of the specific FlashCopy logical drive for
which you want to stop a rollback operation. Enclose the
FlashCopy logical drive name in square brackets ([ ]). If
the FlashCopy logical drive name has special characters,
you must also enclose the FlashCopy logical drive name
in double quotation marks (" ").