IBM System Storage DS3000 Programming Manual page 117

repositoryFullLimit=percentValue |
autoDeleteLimit=numberOfEnhancedFlashCopyImages |
enableSchedule=(TRUE | FALSE)
schedule=(immediate | flashcopySchedule)]
DITA
DITA
Parameters
Parameter
userLabel
sourceLogicalDrive
repositoryLogicalDrive
Description
The name that you want to give the new Enhanced
FlashCopy group. Enclose the Enhanced FlashCopy
group identifier in double quotation marks (" ").
The name of the logical drive that you want to use as the
source for your Enhanced FlashCopy images. Enclose the
source logical drive name in double quotation marks ("
").
The name of the repository logical drive that will contain
the Enhanced FlashCopy group.
You have two options for defining the name of a
repository logical drive:
v Use an existing repository logical drive: name
v Create a new repository logical drive when you run
this command
The name of an existing repository logical drive is
comprised of two parts:
v The term repos
v A four digit numerical identifier that you assign to the
repository logical drive name
Enclose the name of the existing repository logical drive
in double quotation marks (" ").
If you want to create a new repository logical drive
when you run this command you must enter the name
of either a an subsystem or a disk pool in which you
want the repository logical drive. Optionally, you can
also define the capacity of the repository logical drive. If
you want to define the capacity you can use these
values:
v An integer value that represents a percentage of the
base logical drive capacity
v An decimal fraction value that represents a percentage
of the base logical drive capacity
v A specific size for the repository logical drive. Size is
defined in units of bytes, KB, MB, GB, or TB.
If you do not use the capacity option, the storage
management software sets the capacity to 20 percent of
the base logical drive capacity.
Enclose the name of the new repository logical drive in
parenthesis ( ).
Chapter 3. Script Commands
3-71