IBM System Storage DS3000 Programming Manual page 52

Clear Storage Subsystem Firmware Pending Area
DS3000: 6.17.xx.xx
DS4000: 6.1x.xx.xx
DS5000: 7.3x.xx.xx
Clear Storage Subsystem Recovery Mode
DS3000: 7.83.xx.xx and later
DS4000: N/A
DS5000: N/A
Configure Automatic Support Bundle Collection
DS3000: 7.xx.xx.xx
DS4000: 7.xx.xx.xx
DS5000: 7.3x.xx.xx
Note: This command is only compatible with Storage Manager version 10.83 and later.
®
Convert FlashCopy Logical Drive to Enhanced FlashCopy Group
DS3000: 7.83.xx.xx and later
DS4000: N/A
DS5000: N/A
Create subsystem
DS3000: 6.17.xx.xx
DS4000: 6.1x.xx.xx
DS5000: 7.3x.xx.xx
Note:
v For version 7.60.xx.xx, you can change the drive parameter to accommodate the enclosures
with internal disk drawers.
v 7.77 adds the T10 PI parameter.
Create Consistency Group
DS3000: 7.8x.xx.xx
DS4000: N/A
DS5000: N/A
Create Consistency Group Enhanced FlashCopy Image
DS3000: 7.83.xx.xx and later
DS4000: N/A
DS5000: N/A
Create Consistency Group Enhanced FlashCopy Logical Drive
DS3000: 7.83.xx.xx and later
DS4000: N/A
DS5000: N/A
Create Consistency Group Enhanced FlashCopy Logical Drive Mapping
DS3000: 7.83.xx.xx and later
DS4000: N/A
3-6
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide