Stop Controller Diagnostic; Stop Disk Pool Locate; Stop Drive Channel Fault Isolation Diagnostics - IBM System Storage DS3000 Programming Manual

Stop Controller Diagnostic

This command stops the controller diagnostic tests that were started by the start controllerdiagnostic
command.
Syntax
stop controller [(a | b)] diagnostic
Parameters
Parameter
controller

Stop Disk Pool Locate

This command turns off the indicator lights on the drives that were turned on by the start diskPool
locate command.
Syntax
stop diskPool locate
Parameters
None.

Stop Drive Channel Fault Isolation Diagnostics

This command stops the drive channel fault isolation diagnostics, which stops the start drive channel
fault isolation diagnostics command before it completes.
See the "Start Drive Channel Fault Isolation Diagnostics" on page 3-292 command for more information.
Syntax
stop driveChannel faultDiagnostics
Parameters
None.
Notes
Use the start driveChannel faultDiagnostics command and the save driveChannel faultDiagnostics
command with the stop driveChannel faultDiagnostics command. These commands are needed to start
the diagnostic test and save diagnostic test results to a file.
You can also stop the start driveChannel faultDiagnostics command at any time by pressing Ctrl+C.
Description
The setting to return information about a specific controller
in the storage subsystem. Valid controller identifiers are aor
b, where a is the controller in slot A, and b is the controller
in slot B. Enclose the controller identifier in square brackets
([ ]). If you do not specify a controller, the storage
management software returns a syntax error.
Chapter 3. Script Commands
3-309