Start Storage Subsystem Isns Server Refresh; Stop Array Locate; Stop Cache Backup Device Diagnostic; Stop Cache Memory Diagnostic - IBM System Storage DS3000 Programming Manual

Start Storage Subsystem iSNS Server Refresh

This command initiates a refresh of the network address information for the iSNS server. If the DHCP
server is marginal or unresponsive, the refresh operation can take from two to three minutes to complete.
Note: This command is for IPv4 only.
Syntax
start storageSubsystem isnsServerRefresh
Parameters
None.
Notes
If you used the set storageSubsystem isnsIPv4ConfigurationMethod command to set the configuration
but did not set the configuration to DHCP, running the start storageSubsystem isnsServerRefresh
command returns an error.

Stop array locate

This command turns off the indicator lights on the disk drives that were turned on by the start array
locate command.
Syntax
stop array locate
Parameters
None.

Stop Cache Backup Device Diagnostic

This command stops the cache backup device diagnostic tests that were started by the
startcacheBackupDevice diagnostic command.
Syntax
stop cacheBackupDevice controller [(a | b)] diagnostic
Parameters
Parameter
controller

Stop Cache Memory Diagnostic

This command stops the cache memory diagnostic tests that were started by the start
cacheMemorydiagnostic command.
3-306
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
Description
The controller that has the cache backup device on which
you are running the diagnostic tests. Valid controller
identifiers are a or b, where a is the controller in slot A, and
b is the controller in slot B. Enclose the controller identifier
in square brackets ([ ]). If you do not specify a controller, the
storage management software returns a syntax error.