Reset Controller - IBM System Storage DS3000 Programming Manual

Parameter
sampleType
Notes
Statistics are reset for mirrored volumes in the Primary role. The statistics that are reset include the
following data:
v Synchronization start time
v Synchronization type (manual or periodic)
v Synchronization duration
v Number of bytes sent
v Maximum and minimum write time (for a single write)
v Maximum and minimum synchronization data rate
v Total write time
v Repository utilization (%)
v Recovery point age
Minimum Firmware Level
7.84

Reset Controller

This command resets a controller, and it is disruptive to I/O operations.
Important: When you reset a controller, the controller is removed from the data path and is not available
for I/O operations until the reset operation is complete. If a host is using logical drives that are owned
by the controller being reset, the I/O directed to the controller is rejected. Before resetting the controller,
either make sure that the logical drives that are owned by the controller are not in use or make sure that
a multi-path driver is installed on all of the hosts that use these logical drives.
Syntax
reset controller [(a | b)]
3-158
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
Description
This parameter is optional. The default value for
sampleType is all
v all— Data for all three sample types are reset.
mostRecent — Statistics are reset for the most recent
v
50 resynchronization samples.
longestSyncTime — Statistics are reset for the most
v
recent 20 longest resynchronization samples.
v errors— Statistics are reset for the most recent 20
failed resynchronization samples.
.