Set Storage Subsystem - IBM System Storage DS3000 Programming Manual

Parameters
Parameter
errorAction
password
performanceMonitorInterval
performanceMonitorIterations
Notes
When you use this command, you can specify one or more of the optional parameters.
Passwords are stored on each storage subsystem in a management domain. If a password was not
previously set, you do not need a password. The password can be any combination of alphanumeric
characters with a maximum of 30 characters. (You can define a storage subsystem password by using the
set storageSubsystem command.)
The polling interval and the number of iterations that you specify remain in effect until you end the
session. After you end the session, the polling interval and the number of iterations return to their default
values.

Set Storage Subsystem

This command defines the properties of the storage subsystem.
Syntax
set storageSubsystem alarm=(enable | disable | mute)|
{autoSupportConfig (enable | disable) |
cacheBlockSize=cacheBlockSizeValue
cacheFlushStart=cacheFlushStartSize
cacheFlushStop=cacheFlushStopSize
defaultHostType=("hostTypeName" | hostTypeIdentifier)
failoverAlertDelay=delayValue |
mediaScanRate=(disabled | 1-30) |
password="password" |
userLabel="storageSubsystemName"
isnsRegistration=(TRUE | FALSE))
Description
How the session responds if an error is
encountered during processing. You can choose
to stop the session if an error is encountered, or
you can continue the session after encountering
an error. The default value is stop. (This
parameter defines the action for execution
errors, not syntax errors. Some error conditions
might override the continue value.)
The password for the storage subsystem.
Enclose the password in double quotation
marks (" ").
The frequency of gathering performance data.
Enter an integer value for the polling interval, in
seconds, for which you want to capture data.
The range of values is 3 to 3600 seconds. The
default value is 5 seconds.
The number of samples to capture. Enter an
integer value. The range of values for samples
captured is 1 to 3600. The default value is 5.
Chapter 3. Script Commands
3-235