Show Controller Nvsram - IBM System Storage DS3000 Programming Manual

HOST TYPE
ASSOCIATED INDEX
AIX
AIX-ADT/AVT
DEFAULT
HP-UX
HPXTPGS
IBM TS SAN VCE
Irix
LNXCLVMWARE
Linux
Mac OS X
Netware Failover
Solaris (with Veritas DMP)
Solaris (with or without MPXIO)
Windows 2000/Server 2003/Server 2008 Clustered
Windows 2000/Server 2003/Server 2008 Clustered
(supports DMP)
Windows 2000/Server 2003/Server 2008 Non-Clustered
(Default)
Windows 2000/Server 2003/Server 2008 Non-Clustered
(supports DMP)

Show Controller NVSRAM

The show controller NVSRAM command returns a table of values in the controller NVSRAM that is similar
to that shown in this example. With the information from the table, you can modify the contents of the
NVSRAM by using the set controller command. This example shows information for a controller in
slot A in a controller module. You can produce a similar table for a controller in slot B, or you can
produce a table for both controllers.
Attention: Incorrectly setting the NVSRAM can severely affect the performance and the availability of
the subsystems. You should only modify the NVSRAM settings according to the latest information
documented for your configuration in DS4000 publications, readmes, or by your IBM support
representative.
Controller "a":
Region 226:
0000: 4942 4d20 2020 2020 3138 3138 2020 2020
0010: 2020 2020 2020 2020 3037 3330 0000 0000
0020: 0000 0000 0000 0000 0000 0000 0000 0000
0030: 0000 0008 5600 0000 0000 0000 0000 0000
Region 232:
0000: 0000 0000 0000 0000 0000 0000 0000 0000
0010: 5500 0000 0000 0000 0000 0000 0000 0000
Region 233:
IBM.....1818....
........0730....
................
....V...........
................
U...............
Chapter 12. Examples of Information Returned by the Show Commands
ADT STATUS
Disabled 6
Enabled 4
Disabled 0
Enabled 7
Disabled 17
Enabled 12
Disabled 10
Disabled 13
Enabled 5
Enabled 1
Enabled 11
Enabled 14
Disabled 8
Disabled 3
Enabled 15
Disabled 2
Enabled 9
12-41