disk surface. Once the FDE drive is placed into "secured state", it will stay in the secure state until one
re-provision the FDE drive.
Enable Controller Data Transfer
This command revives a controller that has become quiesced while running diagnostics.
Syntax
enable controller [(a | b)] dataTransfer
Parameter
Parameter
controller
Enable Disk Pool Security
This command converts a non-secure disk pool to a secure disk pool.
Note: All of the drives that comprise the disk pool must be security capable.
Syntax
enable diskPool [diskPoolName] security
Parameters
Parameter
diskPool
Notes
Each disk pool name must be unique. You can use any combination of alphanumeric characters,
underscore (_), hyphen(-), and pound (#) for the user label. User labels can have a maximum of 30
characters.
Enable External Security Key Management
This command enables external security key management for a storage subsystem that has full disk
encryption drives.
Syntax
enable storageSubsystem externalKeyManagement
file="fileName" |
passPhrase="passPhraseString"
Description
The controller that you want to revive. Valid controller
identifiers are a or b, where a is the controller in slot A, and
b is the controller in slot B. Enclose the controller identifier
in square brackets ([ ]). If you do not specify a controller,
the storage management software returns a syntax error.
Description
The name of the disk pool that you want to place in the
Security Enabled state. Enclose the disk pool identifier in
square brackets ([ ]).
Chapter 3. Script Commands
3-131