Activate Storage Subsystem Firmware; Activate Enhanced Remote Mirroring; Add Logical Drive To Enhanced Global Mirror Group - IBM System Storage DS3000 Programming Manual

Activate Storage Subsystem Firmware

This command activates firmware that you have previously downloaded to the pending configuration
area on the controllers in the storage subsystem.
Syntax
activate storageSubsystem firmware
Parameters
None.

Activate Enhanced Remote Mirroring

This command creates the mirror repository logical drive and activates the Enhanced Remote Mirroring
premium feature. When you use this command, you can define the mirror repository logical drive in one
of three ways:
Syntax
v User-defined drives
v User-defined Volume Group
User-defined number of drives
v
If you choose to define a number of drives, the controller firmware chooses which drives to use for the
mirror repository logical drive.
Note: In previous versions of this command the feature identifier was remoteMirror. This feature
identifier is no longer valid and is replaced by syncMirror.
activate storagesubsystem firmware
Parameters
None

Add logical drive to Enhanced Global Mirror Group

This command adds a primary logical drive to an Enhanced Global Mirror group. This command is valid
only on the local storage subsystem that contains the Enhanced Global Mirror Group to which you want
to add the primary logical drive. An Enhanced Global Mirror Group has a repository logical drive that is
used to save data for all of the point-in-time images that are part of the Enhanced Global Mirror Group.
Each primary logical drive in the Enhanced Global Mirror Group has a corresponding mirror logical
drive on a remote storage subsystem.
Syntax
add logicalDrive="logicalDriveName"
enhancedGlobalMirrorGroup="enhancedGlobalMirrorGroupName"
remotePassword="password"
(repositorylogicalDrive="repos_xxxx" |
repositorylogicalDrive=(logicalDriveGroupName
[capacity=capacityValue])
repositorylogicalDrive=(diskPoolName
[capacity=capacityValue]))
3-39
Chapter 3. Script Commands