Set Host Group; Set Host Port - IBM System Storage DS3000 Programming Manual

Parameters
Parameter Description
hostChannel The identifier number of the host channel for which you want to
set the loop ID. Enclose the host channel identifier number in
square brackets ([ ]).
Valid host channel values are a1, a2, a3, a4, a5, a6, a7, or
a8 for controller A host ports, and b1, b2, b3, b4, b5, b6, b7,
or b8 for controller B host ports. Depending on the number of
host channels that are currently installed in your storage
subsystems, you can specify two, four or up to 8 host channels
per controller.
For example the DS5100 and DS5300 series controller modules,
valid host channel values are a1, a2, a3, a4, a5, a6, a7, a8,
b1, b2, b3, b4, b5, b6, b7, or b8.
The new port ID for the specified host channel. Port ID values
preferredID
are 0 to 127.

Set Host Group

This command renames a host group.
Syntax
set hostGroup [hostGroupName]
userLabel="newHostGroupName"
Parameters
Parameter Description
The name of the host group that you want to rename. Enclose the
hostGroup
host group name in square brackets ([ ]). If the host group name
has special characters, you also must enclose the host group name
in double quotation marks (" ").
The new name for the host group. Enclose the new host group
userLabel
name in double quotation marks (" ").
Notes
You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Names can have a maximum of 30 characters.
Related Topic
Naming Conventions

Set Host Port

This command changes the host type for an HBA host port. You can also change an HBA host port label
with this command.
Syntax
set hostPort [portLabel] host="hostName" userLabel="newPortLabel"
3-214
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide