Show Storage Subsystem Auto Configure - IBM System Storage DS3000 Programming Manual

LOGICAL DEVICES OPERATION
Logical Drive-2
The information fields returned by the longRunningOperations parameter have these meanings:
v NAME is the name of a logical drive that is currently in a long running operation. The logical drive name
must have the "Logical Drive" as a prefix.
v OPERATION lists the operation being performed on the subsystem or logical drive.
v % COMPLETE shows how much of the long running operation has been performed.
v STATUS can have one of these meanings:
– Pending – The long running operation has not started but will start after the current operation is
completed.
– In Progress – The long running operation has started and will run until completed or stopped by
user request.
v TIME LEFT indicates the duration remaining to completing the current long running operation. The time
is in an "hours minute" format. If less than an hour remains, only the minutes are shown. If less than a
minute remains, the message "less than a minute" is shown.
The logicalDriveDistribution parameter returns information in this form:
logicalDrive name: 10
Current owner is controller in slot: A
logicalDrive name: CTL 0 Mirror Repository
Current owner is controller in slot: A
logicalDrive name: Mirror Repository 1
Current owner is controller in slot:A
logicalDrive name: 20
Current owner is controller in slot:A
logicalDrive name: JCG_Remote_MirrorMenuTests
Current owner is controller in slot:A
The feature parameter returns information about the premium features in this form:
PREMIUM FEATURE
driveSlotLimit
SSDSupport
highPerformanceTier
remoteMirror
safeStoreExternalKeyMgr
safeStoreSecurity
VolumeCopy

Show Storage Subsystem Auto Configure

This command shows the default auto-configuration that the storage subsystem creates if you run the
autoConfigure storageSubsystem command. If you want to determine whether the storage subsystem can
support specific properties, enter the parameter for the properties when you run this command. You do
not need to enter any parameters for this command to return configuration information.
Syntax
show storageSubsystem autoConfiguration
[driveType=(fibre | SATA | SAS)
driveMediaType=(HDD | SSD | unknown | allMedia)
raidLevel=(0 | 1 | 3 | 5 | 6)
subsystemWidth=numberOfDrives
3-272
IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
STATUS
Logical drive Disk Copy 10% COMPLETED 5 min
TIME REMAINING
STATUS
Enabled (12 of 192 used)
Disabled - Feature Key required
Disabled - Feature Key required
Disabled/Deactivated - Feature Key required
safeStoreExternalKeyMgr
Disabled - Feature Key require
Disabled - Feature Key required