Thermo Scientific VF-F20-A Operating Manual page 51

Integral Fraction Collector FT (VF-F20-A) Operating Manual
Figure 13: Carrying handles on the device
No. Component
1 Carrying handles
2 Attachment screw (one on each carrying handle)
4. Place the device on a stable surface.
5. If applicable
Remove any additional packing material. Leave any protective films
attached to the surfaces of the device until it is properly positioned
in the system stack.
6. Transport the device by the carrying handles to the installation site,
if it is not already there, and place it in the system stack. See
Arrangement ( Page
7. On each carrying handle, loosen the attachment screw until the
carrying handle is moveable in the rail. Do not remove the screws
from the carrying handles completely.
8. Slide off the carrying handles from the rails towards the rear of the
device.
Figure 14: Sliding off the carrying handle from the left rail
TIP Keep the shipping container, the carrying handles with the
attachment screws, and all packing material. These items will be
needed if the device is transported to a new location or shipped.
•
4
63).
Unpacking and Transport
System
Page 51