Power Up Procedure - Extron electronics SMP 300 Series User Manual

Power Up Procedure

NOTE: Before powering the SMP 300 Series, ensure that all necessary devices are
Connect the power cord to a 100 to 240 VAC supply (see
page 16). The unit undergoes self testing during the boot sequence (see figure 11 and
figure 12). After the sequence is complete (and when the device is not being configured or
has an active alarm), the default display cycle is on the LCD display.
EXTRON
Power
ELECTRONICS
On
LOADING
FIRMWARE
Figure 11.
NOTE: The information shown in the default display cycle differs depending on
2
EXTRON
Power sec.
ELECTRONICS SMP 35x FW V1.06
On
~4
sec.
30
LOADING
sec.
FIRMWARE
Figure 12.
The default display cycle varies depending on the input video signal and output stream
selection. It shows the selected inputs and their resolutions, stream bit rate, and output
resolution. During recording, the current length of the recording and time remaining are
added to the default cycle.
connected properly. Devices do not need to be powered.
2
EXTRON
sec.
SMP 35x FW V1.06
~4
sec.
45
30
SMP 35x sec.
sec.
INITIALIZING
Boot Sequence and Default Display Cycle for Composite Mode
the active input and the type of video signal. Time Record only displays during a
recording. Time Remain displays the remaining time in the event and the estimated
recording time available during an unscheduled recording.
EXTRON
45
SMP 352
sec.
INITIALIZING
Boot Sequence and Default Display Cycle for Dual Channel Mode
Power Connection
Default Display Cycle
2
In 1 1024x768@60 sec. ARCHIVE
In 3 720p@60 1280x720@30 fps
2 sec.
2
sec.
TIME REMAIN TIME RECORD
HH:MM:SS
Default Display Cycle
2
In 1 1024x768@60
sec. CHA 5.0 MB
In 3 720p@60
1280x720@30 fps
2 sec. 2 sec.
2
sec.
TIME REMAIN TIME RECORD
HH:MM:SS HH:MM:SS
SMP 300 Series • Front Panel Operations
on
5.0 MB
2 sec.
HH:MM:SS
2 sec.
CHB 5.0 MB
1280x720@30 fps
2 sec.
25