Rear Panel Reset - Extron electronics SMP 300 Series User Manual

Rear Panel Reset

The Reset button on the rear panel of the SMP 300 Series (see
returns the SMP 300 Series to various modes of operation. There are three unit reset modes
(numbered 1, 4, and 5) that are initiated from the rear panel reset button. To select different
reset modes, use a pointed stylus or small screwdriver to press and hold the Reset button
when the SMP 300 Series is powered on or press and hold the Reset button while applying
power to the SMP 300 Series.
NOTES:
ATTENTION:
See figure 7 and the
modes.
Figure 7.
• The reset modes listed in the
close all open IP and Telnet connections and all sockets. The table has details
comparing the reset modes and detailing affected configuration settings and user
content.
• Each reset mode is a separate reset (not a continuation from mode 1 to mode 5).
• Reset modes 2 and 3 are not available for the SMP 300 Series.
• The SMP 300 Series can also be reset using the web-based user interface (see
System Resets on page 102).
• For information on resetting the SMP 300 Series using SIS commands see
on page 116.
• Review the reset modes carefully. Some reset modes delete all user loaded
content and revert the device to default configuration.
• Analysez minutieusement les différents modes de réinitialisation. Certains modes
de réinitialisation suppriment l'intégralité du contenu chargé de l'utilisateur et
remettent l'appareil au mode de configuration par défaut.
SMP 300 Series Reset Modes
Mode 1
RESET
Press and hold
the Reset button.
Mode 4
RESET
Press and hold
for 6 seconds.
Mode 5
RESET
Press and hold
for 9 seconds.
Resetting the SMP 300 Series
SMP 300 Series Reset Modes
table for a summary of the reset
RESET
Apply power
to the SMP.
Release, then immediately
press and release again.
Reset LED flashes twice.
Reset LED flashes, then goes off.
RESET RESET
Release, then immediately
press and release again.
Reset LED flashes three
Reset LED flashes, then goes off.
times.
RESET RESET
SMP 300 Series • Installation
figure 4 on page 15)
table on page 20
Resets
Release Reset button.
19