Comm Settings (View And Edit) Menu - Extron electronics SMP 300 Series User Manual

Record Drive Limiter
Configure the record drive locations to be limited or to be fully
automatic. The following limitations can be selected:
• OFF (not restricted, default) — Record to internal memory
and any connected drives.
• ON
Based on the top level selection, the REC LOCATION submenu under Record/Stream
Config offers different record drive options (see
Menu on page 33).
Reset
The Reset submenu provides a factory reset or firmware
reboot. The selections are:
To Factory — Equivalent to a ZQQQ command (see
•
Resets
with the current firmware.
Reboot Unit — Identical to a power cycle.
•
A reset or reboot confirmation message appears before the reset or reboot. After confirming,
the front panel LCD displays Resetting/Rebooting Unit.
NOTE: The factory configured passwords for all accounts on this device have been set
to the device serial number. In the event of a complete system reset, the passwords
convert to the default, which is no password (see
change a password).

Comm Settings (View and Edit) Menu

The two Comm Settings menus provide a status of the
current serial port and IP settings for the communications
ports. A hidden menu allows changes to the settings.
The main menu defaults to the VIEW COMM SETTINGS
submenus for viewing all communication port settings.
Press NEXT to cycle through the submenu.
The VIEW COMM SETTINGS submenu is read‑only. To
make changes, press and hold NEXT and INPUT 5
simultaneously for 3 seconds in the VIEW COMM SETTINGS
menu or any of the submenus. The VIEW COMM SETTINGS
menu changes to the EDIT COMM SETTINGS menu.
on page 116). The unit is reset to factory defaults
PREVIEW HDMI OUT
<1280X720@60Hz>
AUTO MEMORY
RECORD DRIVE LIMITER
TEST PATTERN
Record and Stream Configuration
RECORD DRIVE LIMITER
Users and Roles
VIEW COMM
SETTINGS
"Hidden" Menu*
EDIT COMM
SETTINGS
NEXT
SERIAL PORT
9600 RS232
Rotate either to change
the baud rate.
NEXT
MAC ADRESS
005A6078CEC
This is set at the factory and cannot be
changed. (Skipped in "Edit" mode.)
NEXT
DHCP MODE
<OFF> On
Rotate either to toggle
DHCP mode On or Off.
NEXT
IP ADDR
192.168.254.254
Rotate [ to select octet field.
Rotate { to change address.
NEXT
SUBNET
255.255.000.000
Rotate either to change mask.
NEXT
GATEWAY
000.000.000.000
Rotate [ to select octet field.
Rotate { to change address.
SMP 300 Series • Front Panel Operations
AUTO MEMORY
<ON>
NEXT
Rotate { to toggle Auto
Memory On or Off.
NEXT
Rotate either to select
a resolution.
TEST PATTERN
<N/A>
NEXT
Rotate either to select a
test pattern.
<ON>
NEXT
Rotate { to toggle Auto
Memory On or Off.
<OFF/ON>
NEXT
Rotate either to select
the drive restriction.
<N/A>
NEXT
Rotate either to select a
test pattern.
RESET
<NONE>
NEXT
Rotate either to select
reboot or to reset all
<OFF/ON>
advanced configurations.
Rotate either to select NEXT
the drive restriction.
NEXT
RESET
<NONE>
Rotate either to select
reboot or to reset all
advanced configurations.
NEXT
on page 86 to
Press and hold
INPUT 5 + NEXT
for 3 seconds.
46