Extron electronics SMP 300 Series User Manual page 100

To set a recording file size limit:
In the System Settings page, click the Recording Limits panel bar.
1.
Figure 71. Limit Recording Size
2. Select (check) the Recording File Size Limiter checkbox (see figure 71,
3. Enter a number into the Maximum File Size field or use the Up and Down arrows (
next to the field to select a number. The file size can be limited to any size between
100 MB to 3800 MB (3.8 GB).
The default is 3584 MB.
•
If the Recording File Size Limiter checkbox is deselected, the size limit
•
function is disabled, and the entire recording is stored in a single file.
4. Click Save, or Cancel (
NOTE: For an SMP set for secondary storage mode with unlimited file size selected, the
recording saved on the internal storage drive is saved in a single file. However, if the
recording is saved to a USB storage device with FAT32 formatting, recording creates
multiple 4 GB files as a result of the FAT32 size limit. Use a USB drive formatted for
NTFS in order to avoid the file size limit.
Ad hoc recordings can be limited to a specific duration. If this feature is enabled, the SMP
stops recording an event after the specified number of hours.
To limit the ad hoc recording duration:
In the System Settings page, click the Recording Limits panel bar.
1.
Figure 72. Limit Ad hoc Recording Duration
2. Select (check) the limit Recording Ad hoc Duration Limiter checkbox (see figure 72,
).
1
3. Enter a number into the Maximum Ad hoc Record Duration field or use the Up and
) next to the field to select a number from 0 to 24 hours.
Down arrows (
2
By default, the Recording Ad hoc Duration Limiter checkbox is not checked
•
and there is no limit on duration.
• Enter time in full hours only. Fractions of an hour are not saved.
4. Click Save, or click Cancel (
) to discard the changes.
3
) to discard the changes.
3
SMP 300 Series • Web-Based User Interface
).
1
)
2
92