Extron electronics SMP 300 Series User Manual page 98

Setting the Default Recording Media
To choose where a recording is saved during its creation:
NOTE: Secondary storage mode is not available and cannot be selected if dual channel
encoding mode is active.
1. In the System Settings page, click the Recording Media Selection panel bar.
Figure 69. Recording Media Selection Panel
2. Use the drop-down lists in Set Recording Destination Priority (see figure 69,
to designate where the SMP stores a recording when Auto is selected as the recording
destination or a recording destination is unavailable.
The default destination priority is: RCP USB, Front USB, Rear USB, Internal.
3. An Admin can disable one or more Record Destinations to prevent a user from
recording to that location by deselecting the checkbox or checkboxes. For example, if
the Front USB is deselected, the SMP does not recognize a USB drive inserted into the
Front USB port, and the recording file is not saved to this Record Destination.
To save recordings to a single location (to use single storage mode):
a. Verify that the Secondary Recording Enabled checkbox (
(unchecked).
b. Select the checkbox or checkboxes in the Record Destination panel (
enable recording destinations.
• Internal — This forces the unit to store recordings only in its internal storage,
even if USB drives are attached to the front and rear panel ports.
• Front USB, Rear USB, or RCP USB — These options force the unit to record to
a USB drive connected to the corresponding port.
NOTES:
• At least one record location must be enabled as a record destination.
• The Internal recording destination must be enabled for file publishing.
The SMP automatically uploads recording files to a network server only if
•
files are recorded to and stored on the internal drive. If only a USB option is
selected, files cannot be auto-uploaded to a server.
• When a record destination is disabled, the SMP will not report a USB flash
drive attached to a port.
• Secondary recording must be turned off to record virtual input into files.
• The RCP USB location is grayed out if an RCP 101 is not detected.
• All locations are enabled by default. Select the checkbox to deselect.
SMP 300 Series • Web-Based User Interface
)
1
) is disabled
2
) to
3
90