Extron electronics SMP 300 Series User Manual page 44

Record To (Internal + 2nd)
The Record To submenu selects the drive the input records to. Selecting Internal + 2nd
assumes there is a USB drive connected. The input is always recorded to both the internal
and external drives.
NOTE: In Dual Channel mode, Secondary Recording is disabled.
• Internal — Displays the available drive space for the internal drive.
• External — Displays the available drive space of the connected USB drive. If no drive
is currently connected, the drive space shows N/A.
When External is active, rotate the left (
• <USBFRONT [ ]> — An external drive connected to the front panel USB port.
VOLNAME
• <USBREAR [VOLNAME]> — An external drive connected to the rear panel USB port.
<USBRCP [VOLNAME]> — An external drive connected to the RCP USB port.
•
Streaming
Streaming is available in both archive and confidence encodes. Streaming can be ON
(enabled) or OFF. When streaming is enabled, the STREAM METHOD, STREAM PROTOCOL, and
MULTICAST IP or DESTINATION IP submenus are available (see figure 21). The appropriate
submenus are displayed depending on the previous submenu selection.
NOTE: In the menus and submenus, MULTI refers to a multicast protocol and UNI
refers to unicast.
RECORD/STREAM
MENU
CONFIGURATION
NEXT
STREAMING
<ON>
Rotate either to
toggle streaming
on or off.
NEXT
STREAM METHOD
<RTSP PULL>
Rotate either to
select RTSP PULL, RTP
PUSH, or RTMP PUSH.
NEXT
STREAM PROTOCOL
-OR-
<UNICAST>
Rotate either to select protocol.
Press NEXT to select and move
to next submenu.
NEXT
Figure 21. Streaming Submenus
The following submenus appear only when the encoder selection is ARCHIVE. Confidence
encodes have independent stream settings.
[
) ADJUST knob to select from the following:
- OR -
STREAM PROTOCOL
<MULTICAST>
MULTICAST IP
XXX.XXX.XXX.XXX
Rotate [ to select octet.
Rotate { to change address.
NEXT
SMP 300 Series • Front Panel Operations
STREAM METHOD
<PUSH>
NEXT
STREAM PROTOCOL
Rotate either to select protocol
<UNICAST>
from this list:
UNI TS/UDP MULTI TS/UDP
UNI TS/RTP MULTI TS/RTP
UNI ES/RTP MULTI ES/RTP
Press NEXT to select and move
DESTINATION IP
to next submenu.
XXX.XXX.XXX.XXX
Rotate [ to select octet.
Rotate { to change address.
NEXT
36