Extron electronics SMP 300 Series User Manual page 28

Mode Activation
1 Hold in the recessed rear
panel Reset button while
applying power to the unit.
NOTE: Do not operate with the default firmware loaded by a mode 1 reset. Use it only to load the
most current firmware to the device.
*4 Hold in the Reset button
until the Reset LED blinks
twice (once at 3 seconds,
again at 6 seconds). Then,
release and press the
Reset button again within 1
second*.
*5
Hold in the Reset button
until the Reset LED blinks
three times (once at 3
seconds, again at 6 seconds,
again at 9 seconds). Then,
release and press the
Reset button again within 1
second*.
NOTES:
• *For modes 4 and 5, nothing happens if the momentary press does not occur within 1 second.
The factory configured passwords for all accounts on this device have been set to the device serial
•
number. In the event of a complete system reset, the passwords convert to the default, which is no
password (see Users and Roles
SMP 300 Series Reset Modes
Result
The SMP 300 Series reverts to the
factory default firmware for a single
power cycle.
Sets the following back to back to
factory default.
• Port mapping
IP address: 192.168.254.254
•
• Subnet mask address:
255.255.0.0
Gateway IP address: 0.0.0.0
•
Turns DHCP off.
The Reset LED on the rear panel
of the unit flashes four times in
succession.
Performs a complete reset to factory
defaults (except the firmware).
• Does everything mode 4 does.
• Clears port configurations.
• Resets all IP options.
Resets all passwords.
•
• Clears all user settings.
• Clears all files from the unit.
The Reset LED on the rear panel
•
of the unit flashes four times in
succession.
on page 86 to change a password).
Purpose and Notes
Use mode 1 to revert to
the factory default firmware
for a single power cycle if
incompatibility issues arise
with user-loaded firmware.
All user files and settings are
maintained.
Mode 4 is used to set
IP address information using
ARP and the MAC address.
Resetting IP Settings
appears on a connected
display.
Mode 5 is useful to start over
with default configuration and
uploading, and also to replace
events.
Resetting SMP 300 Series
appears on a connected
display.
Mode 5 is equivalent to SIS
command ZQQQ (see SIS
command Absolute reset
page 116).
SMP 300 Series • Installation
on
20