Smp 351 Power Up Procedure; Front Panel Menu Operation; Menu Navigation - Extron electronics SMP 351 User Manual

SMP 351 Power Up Procedure
NOTE: Before powering the SMP 351, ensure that all necessary devices are connected
Connect the power cord to a 100 to 240 VAC supply (see
page 13). The unit undergoes self testing during the boot sequence (see figure 12). After
the sequence is complete (and when the device is not being configured or has an active
alarm), the default display cycle is on the LCD display.
2
EXTRON
Power sec.
ELECTRONICS
On
~4
sec.
30
LOADING
sec.
FIRMWARE
NOTE: The information shown in the default display cycle differs
depending on the active input and the type of video signal.
Time Record displays only during a recording.
Time Remain displays the remaining time in the event and the
estimated recording time available during an unscheduled
recording.
Figure 12.
The default display cycle varies depending on the input video signal and output stream
selection. It shows the selected inputs and their resolutions, stream bit rate, and output
resolution. During recording, the current length of the recording and time remaining are
added to the default cycle (see the NOTE in figure 11, above).

Front Panel Menu Operation

Configuration and adjustments can be performed using the embedded Web pages
(see
Communication and Control
menus displayed on the LCD screen. These menus are used primarily during the initial set
up.

Menu Navigation

Menu display (
menus on a16x2 LCD display.
MENU button (
and cycle through the main menus.
NEXT button (
the submenus of the selected main menu.
ADJUST ([,{) knobs (
rotate the left ([) control and right ({) control to scroll
through submenu options and to make configuration
selections. See the flowcharts in this chapter for details.
properly. Devices do not need to be powered.
EXTRON
SMP 351 FW V1.00
45
SMP 351
sec.
INITIALIZING
Boot Sequence and Default Display Cycle
Web-Based User Interface
) — Displays the configuration
G
CHANNEL A
1 2
CHANNEL B
3 4 5
USB STORAGE
CONFIG
) — Press MENU to activate menus
H
) — Press NEXT to move between
H
I ) — In configuration mode,
Power Connection
Default Display Cycle
In#1 1024x768@60
In#3 720p@60
2 sec.
TIME REMAIN
HH:MM:SS
on page 47), the SIS commands (see
on page 156), or using the front panel controls and the
AUDIO
L R LAYOU T
PRE SET
M ARK S WAP S WAP
Menu
PRESETS
Next
Menu
ENCODER RECALL
<N/A>
Rotate either to
select a preset.
Press
selected preset.
Press
Menu
ENCODER SAVE
<N/A>
Rotate either to select a
preset to save current
settings to.
Press
the new preset.
Press
SMP 351 • Front Panel Operation
on
2
sec. ARCHIVE 2.0 MB
1280x720@10 fps
2 sec.
2
sec.
TIME RECORD
HH:MM:SS
Remote
ADJUST
M ENU
NEXT NEXT
PICTURE
Menu
CONTROL
Next
Menu
CHANNEL SELECT
<A> <ON>
Rotate to select a channel.
Rotate to turn the channel
to recall the on or off.
to continue.
Next
Menu
H POSITION [A] V
<+0000> <+0000>
Rotate to adjust Horizontal
Position.
Rotate to adjust Vertical
to save the Position.
Next
to continue.
SM
I/O
PRESENTATION CAPTURE
1
2
3
4
22